PYCO's factory calibration certification is a proven way to achieve superior boiler control. In addition, ordering a series of assemblies made from the same batch of sensor wire will enable you to determine the inaccuracy of individual assemblies.
That's because any reading taken can be cross referenced with readings from other nearby assemblies. When an eccentric unit is identified, it can be replaced with a PYCOPACK sensor made from the same wire batch, if you initially ordered spares. As a result, the group's calibrated integrity remains intact.
At the next scheduled thermocouple change-out, a new group of PYCO calibrated units should be installed. Once again PYCO will manufacture your thermocouple assemblies from a continuous batch of sensor wire for millivolt output consistency. For best results, thermocouple elements in critical locations should be changed after two years of service.
Utilities around the country have found that using this system to maintain monitoring reliability helps take the guesswork out of boiler control. Why not put this proven way to increase efficiency in fuel consumption, and reduce wear and tear on equipment to work in your facility?